Sony HDW-S280 Operation Manual page 75

Item Item name
number
740 MASTER LEVEL (HD)
741 Y LEVEL (HD)
742 PB LEVEL (HD)
743 PR LEVEL (HD)
745 SETUP (BLACK) LEVEL
(HD)
746 SYNC PHASE (HD)
747 FINE (HD)
a) Not applicable in 24PsF/23.98PsF mode
Note
When you set setup menu items 715 through 718, 721, and
740 through 747, set VID.PROC on the P1 PROCS page of
the function menu to MENU. Then the video output control
function on the front panel is disabled.
Item Item name
number
802 DIGITAL AUDIO MUTING
IN SHUTTLE MODE
807 AUDIO OUTPUT PHASE
808 INTERNAL AUDIO SIGNAL
GENERATOR
810 AUDIO EDIT PREVIEW
SWITCHER
Settings
Adjust the high-definition video signal output from the HD SDI OUTPUT connector.
This adjusts the Y, PB, and PR levels simultaneously.
0.0% (0H) to [100% (800H)] to 141.3% (B4EH)
Adjust the Y level of the high-definition video signal output from the HD SDI OUTPUT
connector.
0.0% (0H) to [100% (800H)] to 141.3% (B4EH)
Adjust the PB level of the high-definition video signal output from the HD SDI OUTPUT
connector.
0.0% (0H) to [100% (800H)] to 141.3% (B4EH)
Adjust the PR level of the high-definition video signal output from the HD SDI OUTPUT
connector.
0.0% (0H) to [100% (800H)] to 141.3% (B4EH)
Adjust the setup level of the high-definition video signal output from the HD SDI
OUTPUT connector.
0 to [110H] to 220H
Control the H sync phase of the high-definition video signal output from the HD SDI
OUTPUT connector according to the menu.
0 to [80H] to FFH
Fine control the H sync phase of the high-definition video signal output from the HD SDI
OUTPUT connector according to the menu.
[0] to 3FFH
Items 800 to 899: Settings for audio control
Settings
Set the digital audio muting conditions during shuttle playback.
[OFF]: Not muted.
CUEUP: Muted during cue-up or preroll operations.
FULL: Muted in shuttle mode.
SLOW: Muted, with the speed less than
Select the output timing of digital audio playback signals (HD SDI, and SDI only). The
reference position corresponds to a setting for 80H; when the setting is less than 80H,
the output timing is advanced, and when it is higher than 80H, the output timing is
delayed. (at 80H, 128 samples = approx. 2.7 ms, and 1 sample=approx. 20 µs)
0 to [80] to FF: Setting in this range
Select the operation of the internal audio test signal generator.
OFF: No operation
SILNC: Silent signal
[1KHZ]: At 1 kHz, −20 dB FS sine wave is supplied to all audio input channels.
Note
If the system frequency is set to 23.98PsF or 24 PsF, the frequency 1kHz is 4% lower.
Set the output phase for the audio playback signal when ASSEMBLE is set to ON.
[INT]: The audio playback signal output phase is the same as the output phase in E-E
mode. Use this setting when editing with a single VTR, or when previewing while
watching the VTR output signal.
EXT: The audio playback signal output phase is the same as the phase of an input
video signal or external reference video signal.
±
0.2 time normal playback.
Items in the Extended Setup Menu
75