Sony HDW-S280 Operation Manual page 72

Item Item name
number
25F STARTING TC SEL (in
24PsF, 23.98PsF mode
only)
24F JUMPING TC SEL (in
b)
622
50i or 25PsF mode only)
25F JUMPING TC SEL (in
24PsF, 23.98PsF mode
only)
630 SEARCH TYPE SELECT
631 REC START MARK MODE
Sub item
1 CRASH REC
2 ASSEMBLE
3 PAUSE REC
651 UMID OUTPUT
653 UMID HD VANC LINE
654 UMID GENERATE
METHOD
72
Items in the Extended Setup Menu
Settings
Select whether the 25F starting timecode is set or not for timecode conversion from
25F to 24F.
[OFF]: Do not set the starting timecode.
ON: Set the starting timecode.
To set the 25F starting timecode
Press the F5 (SET) button with this menu item displayed in the menu display to enter
the starting timecode setting mode. You can then set the user starting timecode digit by
digit using the F3 (C) button and F4 (c) buttons for digit selection. When all required
digits have been set correctly, press the F5 (SET) button again to save the starting
Select one of the following setting for timecode conversion from 24F to 25F.
[–3H]: Set JUMPING TC to "STARTING TC –3H"
–2H: Set JUMPING TC to "STARTING TC –2H"
–1H: Set JUMPING TC to "STARTING TC –1H"
+1H: Set JUMPING TC to "STARTING TC +1H"
+2H: Set JUMPING TC to "STARTING TC +2H"
+3H: Set JUMPING TC to "STARTING TC +3H"
0H: Set JUMPING TC to "STARTING TC –1 frame"
Select one of the following setting for timecode conversion from 25F to 24F.
[–3H]: Set JUMPING TC to "STARTING TC –3H"
–2H: Set JUMPING TC to "STARTING TC –2H"
–1H: Set JUMPING TC to "STARTING TC –1H"
+1H: Set JUMPING TC to "STARTING TC +1H"
+2H: Set JUMPING TC to "STARTING TC +2H"
+3H: Set JUMPING TC to "STARTING TC +3H"
0H: Set JUMPING TC to "STARTING TC –1 frame"
[ALL]: Searching for all shot mark in index search operation
REC: Searching for rec start mark in index search operation
SHOT 1: Searching for shot mark 1 in index search operation
SHOT 2: Searching for shot mark 2 in index search operation
POST: Searching for post mark in index search operation
c)
STOP : Searching for the stop code in index search operation
[OFF]: Not recording the rec start mark
ON: Recording the rec start mark in normal recording.
[OFF]: Not recording the rec start mark
ON: Recording the rec start mark in assemble editing.
[OFF]: Not recording the rec start mark
ON: Recording the rec start mark in back space editing.
Select UMID data output.
[OFF]: Do not output UMID.
BASIC: Output Basic UMID.
EXTND: Output Extended UMID.
Note
Even if EXTENDED is selected, Basic UMID is output if Basic UMID is recorded on the
tape being played back.
Specify the HD SDI signal VANC line into which the UMID should be inserted.
9H to [17H] to 20H
Note
The output VANC line during playback follows the setting for recording.
Select the Instance No. generation method when the UMID is inherited.
[16BIT]: Copy No. + 16-bit random number
24BIT: 24-bit random number
Note
When menu item 656 is set to NEW (an Instance Number indicating that this is the
original is generated), the same value (all zeros) is generated regardless of which of
the above methods is selected.