Table of Contents
Advertisement
Searching Using Various
Functions
The VCR automatically marks the tape with an
index signal at the point where each recording
begins.
You can easily find a specific point using various
search functions.
Note
During DVD recording, you cannot use VCR search
functions.
H
CLEAR
1
Press VIDEO to operate the VCR.
2
Press OPTIONS.
3
Select a search method from the OPTIONS
menu, and press ENTER.
Go to Zero
End Search
Forward Intro Scan
Reverse Intro Scan
Move
ENTER Enter
"Go to Zero": Searches for the 0:00:00 point
on the tape counter.
To reset the counter to 0:00:00, press CLEAR.
76
VIDEO
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
0
0
M/m/</,,
ENTER
OPTIONS
Go to Zero
0:00:00
"End Search": Searches for the beginning of a
blank space. If no blank space is found, the
tape will reach the end.
End search
0:00:13
"Forward Intro Scan"/"Reverse Intro Scan":
Searches for an index mark and plays back for
about five seconds at that point.
Press H (play) to view that programme. If
you do not press H, the VCR automatically
searches for the next index mark, or until it
reaches the end of the tape.
Scan and play
–0:00:01
Notes
• The VCR may not recognize the end of a blank space
depending on its length.
• No index signal is marked if you pause a recording and
then keep recording the same programme. To mark an
index, press x or change the programme position once
during recording pause.
Hide quick links:
Advertisement
Table of Contents
