Prolitec Air/Q 565 User Manual page 25

2. Turn off the power by pressing the power
button in the upper left corner. The blue
light will go off.
3. Remove the plastic tubing from the Top
Output Port.
4. Insert the short section of the removal tool in
behind the top section of the cartridge. Hold-
ing the cartridge with your right hand, push
the removal tool to disconnect the cartridge.
DO NOT TRY TO REMOVE CARTRIDGE
WITHOUT THIS TOOL. There is a removal tool
packed with each appliance.
5. Inspect the o-rings on the air stem for break-
age, deterioration or swelling. Replace as needed.
6. If there is any leakage of fragrance during the cartridge installation, clean it
carefully with a paper towel and some ethanol or another alcohol.
7. Dispose of the empty cartridge in the recycle bin.
Installing the New Cartridge
See instructions on page 19.
Battery Replacement – every two years
(requires 3 Volt CR2032 Lithium battery)
• Pinch the flexible tab of the battery holder located at the bottom center of the
appliance and pull outward. Note the position of the battery.
• Insert the new battery. The positive side of the battery should face the wall. The
battery will have a + or – marking on each side.
Maintenance
23