Prolitec Air/Q 565 User Manual page 14

Installation
Step 4 — Marking the Bottom Anchor Holes
Now you can mark the bottom holes using the mounting bracket as a template.
Hold the mounting bracket in place and screw the flat-head screws half way into
the top anchors. This will prevent the bracket from moving. Now use the pen or
pointy tool to mark the location for the two bottom holes. Unscrew the top screws
and set the bracket aside.
Step 5 — Installing the Bottom Anchors or Screws
Drill a / " pilot hole at the exact spot you marked. For drywall mounting, gently
1
8
hammer the tip of the anchors, then screw them in straight.
Step 6 — Hanging the Mounting Bracket
Hang the mounting bracket by holding the bracket so the top holes match up with
the anchors or wall holes, then screw the 2 short, flat-head screws through the
holes in the bracket. Tighten the screws firmly, but do not crack the bracket.
12