Prolitec Air/Q 565 User Manual page 13

Installation
Step 2 — Marking the Top Anchor Holes
Place the mounting bracket at the desired position. Use the level to make sure the
mounting bracket is horizontal. While holding the bracket level, use a pointy tool
such as a screwdriver or pen to mark the location of the top two holes. Check
again with the level to ensure the bracket is horizontal.
Step 3 — Installing the Top Anchors or Screws
Set the mounting bracket aside. Use an electric drill to make a / " pilot hole at the
1
8
exact location you marked. This will serve as a guide for the anchors or sheet metal
screws. If the appliance is being mounted on drywall, use a hammer to gently tap
the tip of the anchors into the wall. Then screw them straight into the drywall.
Hint: If you use an electric drill with a Phillips driver head, make sure that the head
fits the anchor perfectly, as the anchor or screw can strip easily. Set the drill to a
slow rotation.
11