Makita DHP482 Technical Information page 10

DHP482 Wiring diagram
Lead wires
Put lead wires of LED circuit between
Rib A and Rib B.
Boss A
Fix lead wires in these lead wire
holders.
Rib C
Lead holder A
Flag receptacle
Flag receptacles have to be connected so that their wire
connecting portions are located over the marks of + - poles.
Terminal
Fig. 1
Rib A
Fig. 2
Makita Corporation
Put lead wires of LED circuit between Rib A and Rib B.
Their lead wires must be tight in this area so as not to
make slacks.
Rib B
Fix lead wires in these lead wire
holders.
Note: Do not cross lead wires between
these lead wire holders.
Rib D
Put lead wires of LED circuit
between Rib C and Rib D.
P 10/ 11
LED circuit
Edge of LED circuit