Necessary Repairing Tools; Drill Chuck - Makita DHP482 Technical Information

CAUTION: Repair the machine in accordance with "Instruction manual" or "Safety instructions".

NECESSARY REPAIRING TOOLS

Code No.
1R298 Hex bar 10 with square socket
1R359 Chuck removing tool
-
Hex wrench 10
DISASSEMBLING/ASSEMBLING

1. Drill chuck

DISASSEMBLING
1－1
1. Remove M6x22(-) Flat head screw by
turning it clockwise with Impact driver.
Fix shorter leg of Hex wrench 10 in the
jaws of Drill chuck.
Note: Stable operation is available if you
tighten claws of Drill chuck with a Round
-bit in advance.
6. If it is difficult to remove the chuck, follow the steps below.
8. Grip 1R298 with Drill chuck.
7. Insert 1R298 into DTW450.
9. Firmly hold the grip.
10. Push the upside of Switch to turn 1R298 Counterclockwise.
Description
Impact driver
-bit
1－3
1R298
Makita Corporation
removing Drill chuck
removing Drill chuck (If it is impossible to remove as per the
illustration below, refer to Repair Tool List.)
removing Drill chuck
1－2
2. Set Speed change lever to Low speed mode
designated with 1.
3. Fix shorter leg of Hex wrench 10 in the
jaws of Drill chuck.
–––––
4. In order not to break Spindle, be sure to put the three
circled portions of the tool on workbench.
5. Hit the other end of Hex wrench 10 with Hammer.
DTW450
P 2/ 11
Use for
Hex wrench 10