Makita DHP482 Technical Information page 6

ASSEMBLING
2－7
1. Be sure to assemble so that
the notch in Yoke unit is
positioned on the Gear side
of Armature.
Note:
·
Be careful not to damage
Copper wire of Armature.
·
Be careful not to pinch
your fingers between Fan and
Yoke unit.
Gear
Notch of
Yoke unit
5. When you assemble Motor section to Gear assembly;
·
Protrude Motor section's gear into the internal gears in Gear assembly first.
·
The next, check their gears are engaged each other.
·
Finally, push Motor section to Gear assembly while keeping gear engagement firmly.
6. Assemble Speed change lever to Gear ass'y. (Refer to 3－2)
7. Fit the projection of Housing L into the notch of Yoke unit.
Notch of
Yoke unit
2. Shift the tail of Torsion spring and
hook it to the notch of Brush holder.
Note: Hold "A" to avoid Torsion
spring slipping off.
3. Lift up
Carbon brush.
Carbon brush
Torsion spring
2－9
Projection of Housing L
Makita Corporation
2－8
4. Assemble Yoke unit and Armature
to Brush holder complete.
Yoke unit
A
P 6/ 11
Brush holder complete
Armature