Shutdown; Care And Maintenance - REMKO MD Series Operation,Technology,Spare Parts

Shutdown

Temporary shutdown
1. Allow the indoor unit to run for
2 to 3 hours in air circulation
mode or in cooling mode at the
maximum temperature setting
in order to remove any residual
moisture from the unit.
2. Shut down the unit using the
remote control.
3. Switch off the voltage supply to
the unit.
4. Cover the unit as far as possible
with plastic foil in order to
protect it from the influences of
weather.
Permanent shutdown
Ensure that equipment and
components are disposed of in
accordance with local regulations,
e.g. through authorised disposal
and recycling specialists or at
collection points.
Contact REMKO GmbH & Co. KG
or your contract partner for a list
of specialist companies near you.

Care and maintenance

Regular care and maintenance
serves to ensure trouble-free
operation and long service life of
the unit.
CAUTION
Prior to performing any
work, ensure the equipment
is isolated from the voltage
supply and secured to prevent
accidental switch-on!
Care
Ensure the indoor unit and
■
outdoor component are
protected against dirt, mould
and other deposits.
Clean the equipment using a
■
damp cloth. Do not use any
caustic, abrasive or solvent-
based cleaning products. Do
not use a jet of water.
Type of task
Checks/Maintenance/ Inspections
General
Measure voltage and current
Check compressor/fans are functioning
correctly
Check fan is functioning correctly
Dirt on liquefier/vaporiser
Check refrigerant fill quantity
Check condensation drain
Test insulation
Check moving parts
Sealing test for refrigerant circuit
Clean the fins on the indoor
■
unit and outdoor component
prior to long shutdown periods.
Maintenance
It is recommended that
■
you take out a maintenance
contract with an annual service
from an appropriate specialist
firm.
TIP
This ensures the operational
reliability of your equipment!
NOTE
The statutory regulations
require an annual sealing test
for the refrigerant circuit in
relation to the refrigerant
filling level. The inspection
and documentation is to be
carried out by corresponding
specialist engineers.
•
•
•
•
• •
• •
• •
•
•
•
•
•
•
•
•
•
•
13