Table of Contents
Advertisement
Introduction
Changing the Machine Mode
The machine mode can be changed in the following order in the setup menu.
IBM 3151
!
IBM 3101
!
ADM3A
!
ADM 5
!
ADDSVPA2
!
HZ1500
!
TVI910+ /910
Machine modes are classified into five groups:
•
IBM 3151
•
IBM 3101
SYSTEM ATTACH
t
VT52
t
VT100
t
VT100 CONTROL 7
t
VT200 CONTROL 8
t
TVI920/912
t
TVI925E/925
•
Ten ASCII terminals (ADM 3A, ADM 5, ADDS VP A2,HZI500,
TVI910 + /910, TVI925E/925, and TVI920/912)
•
DEC VT220 (VT220 CONTROL 7/8, VT100, and VT52)
•
SYSTEM ATTACH.
When the machine mode is changed to a new machine mode in a different group
(from VT52 to SYSTEM ATTACH, SYSTEM ATTACH to IBM 3151, IBM
3151 to IBM 3101, IBM 3101 to ADM 3A, or TVI920/912 to VT200 CONTROL
8 in case of using the setup menu), a power-on reset (except the checking of the
internal circuits) is performed. When the machine mode group is changed in the
setup menu, the setup menu for the new machine mode is then displayed.
Note: The machine mode can also be changed by using the Set Control 1
command (see "Set/Read Control 1 Commands/Response" on page 5-12).
1-2
User's Guide for the Cartridge
to
Emulate IBM and DEC Terminals
Advertisement
Table of Contents
