12.13 Switching On The Remote Configuration - insys icom 336 LL Manual

4d/2d ac/dc

Hide thumbs Also See for 336 LL:

Table of Contents

Functions

12.13 Switching on the Remote Configuration

The INSYS Modem 336 LL 4D/2D AC/DC can be configured remotely. It has a remote con-

figuration mode. To configure the INSYS Modem 336 LL 4D/2D AC/DC remotely, a data

connection to the modem to be configured must be established. This can be performed

during a data connection. After switching into the remote configuration mode, AT com-

mands can be sent to configure the INSYS Modem 336 LL 4D/2D AC/DC.

To switch into the remote configuration mode, a data connection must be established

between the modems. If the INSYS Modem 336 LL 4D/2D AC/DC recognizes the character

string "****" in the data stream and if no data traffic takes place after that for 1 second,

the INSYS Modem 336 LL 4D/2D AC/DC will switch to the remote configuration. It will

then send a response and a prompt to enter the password of the remote configuration. A

particular connection type is not mandatory. We recommend using only error-corrected

connections for the remote configuration to avoid AT command transfer errors.

The remote configuration is active as default.

Configuration with AT commands

To turn the remote configuration on, use the

command:

To enter a password for the remote configura-

tion, use the command:

Save the settings with:

INSYS Modem 336 LL

AT*R1

AT*C

AT&W

Table of Contents

Do you have a question about the 336 LL and is the answer not in the manual?