Table of Contents
Advertisement
Telecommunicating Alarm (EF-KIT2)
1 Light the panel up and press the blue menu icon, enter your PIN number then press the 'tick' button.
2. Scroll down to 'devices' using +/- buttons. Press the 'tick' button, then again on 'Add device'.
3. Press the first button on the CCTV/Alarm Link Adaptor for 1 second to trigger learning-in signals. The CCTV/
Alarm Link Adaptor will transmit a Key Fob signal (button 1) to your alarm system.
4. You will then need to confirm your selection on the alarm panel using the 'tick' button before moving on.
5. Press the second button on the CCTV/Alarm Link Adaptor for 1 second to trigger learning-in signals. The
CCTV/Alarm Link Adaptor will transmit a PIR Motion Detector signal (button 2) to your alarm system.
6. Confirm your selection on the alarm panel using the 'tick' button before moving on.
7. When both buttons have been learnt in, exit programming menu and return back to standby mode.
For more information, please refer to your alarm manual section: Adding and using accessories.
Pairing with your Yale Connected Smart Lock
1. Follow and complete the full installation instructions to install both your Yale Connected
Smart Lock and Yale CCTV System.
2. Please make sure the CCTV/Alarm Link Adaptor is inserted into the USB port of the
CCTV DVR, and the Yellow Yale Module is inserted into the Smart Lock.
Please note: The batteries must be removed whilst inserting the Module.
3. Wake up the Smart Lock and enter your master code followed by the # button.
The lock should make two beep sounds.
4. Press the number 4 followed by the # button. If you get an error beep, please take out the batteries
and ensure the module is inserted properly, replace the batteries then repeat the process from step 3.
5. Press number 1 followed by the # button. If you get an error beep, please press number 2 (if Keyfree
Connected) or 3 (if Keyless Connected) then repeat the process from step 3. The lock is now in pairing
mode.
6. On the CCTV/Alarm Link Adaptor, press and hold the button saying 'Keyfob' for 5 seconds until the red light
comes on. Please note: You only have one minute to do this from completing step 5.
7. The Smart Lock will indicate that it has been connected with three ascending beeps for Keyless, for Keyfree
the voice will say 'connected'.
8. On the DVR menu screen, double click 'Unlock' using the mouse which will complete the pairing process.
Please note: When your DVR has been rebooted you may need to first unlock using the DVR screen before
this will work on the Yale CCTV App.
9. On the Yale CCTV App, swipe the information bar left and then press the 'Unlock' button.
26
Keyless
Connected
Keyfree
Connected
Advertisement
Table of Contents
