Table of Contents
Advertisement
Quick Reference: System Operation and Programming
Remote Control Operation
This system is only compatible with the Prestige two (2) button 1-Way remote controls. The matrix below describes how
the remote control will operate the basic system functions. See Owner's Guide for more detailed information
ARM
DISARM
Programming Mode Entry and Exit Procedure
Once the system is installed and powered up, you will use the vehicle ignition and a programmed remote control to set
all system options. Feature options are divided into categories, or Banks, as described throughout this section. Ensure
that at least one remote control is programmed to the system. If not, or if you need to program more remote controls,
use the diagram steps to access Bank 1. The siren and LED will indicate your status and selections. Follow the diagram
below to enter and maneuver through the programming procedure.
5X
Cycle Key ON 5X
1 Chirp = Bank 1
To Enter Programming
(Program Remotes)
Ignition O
1. Cycle the ignition ON 5X ending in the ON position.
2. The system will beep (1) one time, indicating you have accessed Feature Bank 1, Remote Programing.
3. Cycle the ignition OFF/ON.
4. The system will beep (2) two times, Indicating you have accessed Feature Bank 2, Feature Programming.
5. Once you have accessed the desired bank, press the ARM button on the remote control to advance through the
features. The LED will flash a number of times to indicate the feature, based on the charts that follow this section.
The system will chip a number of times to indicate the Option programmed.
6. Once you have accessed the desired feature, press the DISARM button on the remote control to advance through the
feature's setting options. The system will beep a number of times to indicate the Option setting, based on the charts
that follow this section.
7. Once you have made the desired setting, you can press the ARM button on the remote control to advance through
the features within the bank.
8. Once you have completed programming, you MUST turn the ignition key to OFF to exit the programming
mode. Programming will automatically exit after 60sec of inactivity.
10
Bu�on
ARM
DISARM
ARM
DISARM
1X
Cycle Key OFF/ON
To Move Enter Bank 2
(Feature Programming)
... or Exit
Programming
Note: Programming will time out after 60sec with no activity or Ignition Off for 5sec.
Ac�on
Press 1x
Hold 3 Seconds
Press 1x
Hold 3 Seconds
ARM
2 Chirp = Bank 2
Press to Change
Feature
Func�on
Lock
Panic ON
Unlock
Panic OFF
AUX Ch. 3
DISARM
LED Indicates
Press to Change
Feature Selection
Option
Repeat Steps to Program
Another Feature ...
Chirps Indicate
Option Number
APSPS1_RevA_1/19
Advertisement
Table of Contents
