Table of Contents
Advertisement
Quick Reference: System Programming & Diagnostics
Bank 1: Add / Remove Remote Controls
Remote control programming is located in Feature Bank 1. This system will Auto Program all remote control functions.
To Auto Program a remote control:
1. Cycle the ignition key to ON 5x, Ending in ON.
2. The system will beep one (1) time, indicating you have accessed Bank 1, Remote Control Programming.
3. Press the ARM button of each remote control you wish to program. The system will beep to indicate the remote
control is programmed.
4. Turn the ignition key to OFF to exit programming mode, or cycle the ignition key OFF/ON to advance to the next
Feature Bank.
To delete a remote control:
This system will store a maximum of four (4) remote controls in the memory. Additional programmed remote controls
will delete the oldest-programmed remote control.
Bank 2: Security Options
Feature Bank 2
1 Auto Arming
2 Anti Hi-Jacking
3 Tilt Sensor Level
4 Silent Mode
5 Security Notification
6 Parking Light Output
7 Shock Sensor Level
8 Aux Ch.3 Output
9 Override Method
10 Default All Features
Troubleshooting Trigger Zones
Test the doors, hood, trunk, and shock sensor to ensure they trigger the security system. Once triggered, the Parking
Lights flash to indicate the trigger source:
Adjusting the Shock Sensor
1. Arm the system, wait 5-10 seconds, then with an open palm carefully apply impact to areas of the vehicle to test the
shock sensor's sensitivity.
2. To adjust, enter Feature Bank 2 - Feature 7. 1 = Low ; 8 = High.
3. If the proper sensitivity still cannot be achieved, re-locate the shock sensor.
APPS1_RevA_1/19
See pages 5-7 for detailed descriptions.
1 Chirp
2 Chirp
OFF
ON
ON
OFF
1
5
OFF
ON
Siren
Horn
ON
OFF
1
2
1sec Pulse
Latch ON/OFF Latch Until IGN
Custom Code
Default
OFF
ON
4 Tilt / Shock
5 Addi�onal Sensor
6 Loop Input
7 Igni�on Input
Options
3 Chirp
4 Chirp
15
30
3
4
5 Chirp
6 Chirp
5
6
7 Chirp
8 Chirp
7
8
11
Advertisement
Table of Contents
