Table of Contents
Advertisement
Detailed Descriptions: Wire Harness Colors and Functions
Main Harness
See page 12 for the full system diagram.
9. PURPLE/WHITE – Loop Trigger Input (-)
The PURPLE/WHITE wire is used as a Loop Alarm Trigger. If the loop is closed (Connected) when the alarm is armed, the
alarm will trigger if the loop is opened (Disconnected). If the loop is open when the alarm is armed, the Loop Trigger will
be ignored. This can be used to protect the user's helmet or other personal belongings.
10. LIGHT GREEN – Additional Sensor Input (-)
The LIGHT GREEN wire connects a device or switch that, when triggered, supplies a Ground (-) output. If the system is
armed, this input will trigger the alarm.
11. DARK BLUE – AUX CH 3 Output
At its default setting, the DARK BLUE wire connects to any external accessory and supplies Ground (-) when activated
from the remote control.
Note: This wire can be programmed to other output timing configurations. Refer to Feature Programming on page 5.
12. WHITE/BLACK – Siren / Horn Output (+/-)
The WHITE/BLACK wire supplies 12-Volt (+) to power the siren. After mounting the siren, connect its BLACK wire to a
reliable ground source, and connect the WHITE/BLACK wire to the siren's RED wire.
Note: This wire can be programmed to control the vehicle's factory horn. Refer to Feature Programming on page 5.
13. RED/BLUE – LED Output (+/-)
The RED/BLUE wires are used to control the alarm LED. These wire can be extended if needed.
14. BLACK/WHITE – RF Antenna
The BLACK/WHITE wire is the system's RF Antenna. This length of this wire should not be changed. Avoid coiling this wire
as operating range will be diminished. When installed, the antenna should extend out from the main module.
APPS1_RevA_1/19
3
Advertisement
Table of Contents
