Using Your Remote Control - Voxx Electronics PRESTIGE APSSECRS Owner's Manual

Using Your Remote Control

Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the
button. The parking lights will flash one (1) time, indicating the
system is armed, has locked the doors (if equipped and connected)
and activated the starter disable feature. The LED status indicator
will blink steadily, once per second.
Disarming the Security System
To disarm the system press the
two (2) times, indicating the system is disarmed and has unlocked
the doors (if equipped and connected).
Manually Overriding the Security System
Your system can be disarmed without the use of the transmitter.
This is necessary, since you will need the ability to operate your
vehicle if the transmitter is lost or its battery fails. To by-pass the
alarm system;
1. Open the vehicle door. The alarm will sound.
2. Cycle the ignition key ON, OFF, ON.
3. Within ten (10) seconds, press and release the Brake pedal
three (3) times.
The alarm system will stop sounding and enter the (by-passed)
mode. You can now start and operate the vehicle normally. This
feature must be programmed ON by an authorized dealer.
Valet Mode
Your system can be disabled to prevent the alarm from triggering
accidently while it is being serviced or driven by a valet driver. To
enter or exit Valet Mode;
1. Open the vehicle door.
2. Cycle the ignition key ON, OFF, ON.
3. Within ten (10) seconds, press and release the Brake pedal
three (3) times.
The system will enter Valet Mode and the LED, if Installed, will
illuminate solid. Repeat the procedure above to exit Valet Mode
2020 Voxx Electronics Corporation. All rights reserved.
button. The parking lights will flash
3