Lorentz PS2-150 Series Manual For Installation And Operation page 35

8.1.2 Cable Splicing
To connect the motor cable with a cable extension you
should connect the cable ends with a splicing kit.
It is very important that the cable joints are fully sealed oth-
erwise moisture could cause a short circuit. This will damage
the pump system.
For more information about connecting cable ends with a
splicing kit see the "submersible cable splicing" manual in
the package of the splicing kit.
CAUTION – Cable splice failures are a
common source of errors. Check the splice
for proper connections.
CAUTION – Bad cable splicing can damage
the controller and/or the pump. Such
damage is excluded from the warranty.
Pump Installation
8.2 Pump System Type
Depending on your pump system, please refer to the correct
chapter for installation instructions:
Pump type
Submersible
Surface CS-F
Surface Boost
To determine the type of system you have, please refer to
chapter "3.4 Naming" on page 8.
Chapter
8.3
8.4
8.3
33