Reset To Factory Default; Key Lock Function - Automationdirect.com SOLO Basic User Manual

Chapter 3: Keypad Operation and Setup Parameters
al2d

Reset to Factory Default

Note: Resetting the Temperature Controller back to factory default erases all of the
values entered by the user. Record any necessary settings before proceeding
Warning: Erasing the user entered values may result in a safety hazard and system
malfunction.
The following instructions reset the controller to the factory default.
1
2
3



Key Lock Function

Adjusting paramber of LoC to LoC1 in Operation Mode to lock all keys. LoC2
allows the SV value to be adjusted.
To unlock:
1
To change key lock password:
1
2
3–14
SOLO Basic Temperature Controller User Manual
Alarm 2 Delay
Length of time alarm condition must be active in seconds before alarm
condition is triggered.
Press the button until the parameter
'
to select . Press the
loC1
Press and hold the
;
and release.
Use the button to change the value on the SV display to
.
the button.
;
Display will change from PASS to PArE. Press
to yes and press set button.
Display will be fully lit and then controller will reboot.
; ' •
Press the and
Enter the password to unlock the key. Default password is 0000.
Press the key when KEYP is displayed to enter the password change
'
screen CH6P.
Enter the current password. If the password is correct, nEwP will be
displayed. If the password is incorrect, the screen will return to PV/SV
display mode.
loC
button.
;
and buttons simultaneously for three seconds
.
keys simultaneously in LOCK mode to display KEYP.
appears. Use the
.
1357
to change value from no
.
button
. Press