Operating Multiple Cameras; Visca Over Ip Control - birddog EYES P200 User Manual

Or you can use CAT5/6 T-568B Standard Ethernet cable
•
direct connect between the camera and the controller to
make RS485 connection by following the pin definition
below:
1 8
CAT5/6
Network Cable
RS485
Port
How to make RS485 multiple cameras connection with
•
RS485 standard serial port controller:
VCC-CC45RS
RJ45 TO RS422/485
CONTROL CABLE ADAPTOR
VCC-CC45RS
RJ45 TO RS422/485
CONTROL CABLE ADAPTOR
VCC-CC45RS
RJ45 TO RS422/485
CONTROL CABLE ADAPTOR
NOTE: For RS-232 VISCA control, this unit supports daisy
chain connection for using multiple cameras.
For control details, refer to Operating Instructions of control
keyboard/station software.
You need to match the communication speed (Baud Rate)
•
1. RX – (Orange/White)
2. RX + (Orange)
3. GND (Green/White)
4. --- (Blue)
5. --- (Blue/White)
6. --- (Green)
7. TX – (Brown/White)
8. TX + (Brown)
5. R –
4. R +
3. T –
2. T +
1. GND
RS422
5. R – GND
4. R + RX +
3. T – RX –
2. T + TX +
1. GND TX –
5. R –
4. R +
3. T –
2. T +
1. GND
between the camera and the joystick controller.
You cannot use the RS-232 connections while you are us-
•
ing the RS422/485 connection.

Operating Multiple Cameras

Using RS-232,422/485
Using RS-232 (VISCA), you can connect to 7 cameras.
•
Using RS-422 (VISCA), you can connect to 7 cameras.
•
Using RS-485 (PELCO), you can connect to 255 cameras.
•
Using RS-485 (PELCO), all camera addresses must be
•
set up before the connection. You can set the camera
address by operating OSD menu, or by setting the Dip
Switch on the bottom of the camera. In this case, you can
use multiple control keyboards.

VISCA over IP Control

With VISCA over IP function, you can control the camera us-
ing VISCA protocol on a controller equipped with IP commu-
nication capabilities via LAN.
PoE Power VISCA Over IP Control
The communication specifications of VISCA over IP are fol-
lowings:
Interface: RJ-45 10/100M
•
Interface protocol: IPv4
•
Transport protocol: UDP
•
IP address: 192.168.100.100 By default
•
Port: 52381
•
13
HDMI Video Signal
3G-SDI Video Signal