Installation Instructions - Blodgett KTT-E SERIES Installation Operation & Maintenance

Immediately after unpacking, check for possible ship-
ping damage. If the kettle is found to be damaged, save
the packaging materials and contact the carrier within 15
days of delivery.
1. The kettle must be installed in accordance with:
a. State and/or local codes.
b. In the USA, the National Electrical Code, ANSI/
NFPA-70 (latest edition). In Canada, the Canadi-
an Electrical Code, Part 1, CSA Standard C22.1
(latest edition).
2. Position kettle on counter allowing sufficient rear
clearance from wall to tilt freely and completely with-
out obstruction.
3. Mark four corner locations of appliance base.
4. Remove appliance from counter and locate position
of 4 holes as per Figure 1. Drill four 7/16" diameter
holes.
5. Apply a continuous bead of Silastic or other equiva-
lent sealant along the complete perimeter edge of the
appliance base.
6. Use 5/16-18 Hex Cap Screws with suitable flat wash-
ers to bolt down. Screw length must be 1-1/4 long
plus counter top thickness.
7. Wipe off excess sealant.
8. A Control Box with power supply equivalent to Elec-
9. A waterproof electrical connection for power supply to
10. Ground kettle to terminal provided inside console
11. Turn power ON and check for proper operation.
14 1/2"
368mm
18"
457mm
Figure 2
3

Installation Instructions

trical Rating of appliance should be located conve-
niently nearby.
WARNING
Electrical and grounding connections must
comply with the applicable portions of the
National Electrical Code and/or other local
electrical codes.
WARNING
Disconnect electrical power supply and place
a tag at the disconnect switch to indicate you
are on the circuit.
console housing must be provided.
housing.
1 1"/4
32mm
10"
254mm
12 1/2"
317mm
2 1/4"
57mm
INSTALLATION