Clearances To Combustibles - Re-Verber-Ray DET3 Series Insert Manual

1.0 Safety • Safety Labels and Locations • Clearance to Combustibles
SERVICE ACCESS PANEL
IGNITER & FLAME SENSE COMPARTMENT
1. Turn off gas & electricity.
2. Remove cover by lifting top
cover upward and outward.
CAUTION: HOT SURFACE.
KEEP COVER IN PLACE. REMOVE FOR SERVICE ONLY.
F/N: LLTB026
SERVICE ACCESS PANEL
IGNITER & FLAME SENSE COMPARTMENT
1. Disconnect gas & electricity.
2. Remove cover by lifting top
cover upward and outward.
CAUTION: HOT SURFACE.
KEEP COVER IN PLACE. REMOVE FOR SERVICE ONLY.
SERVICE ACCESS PANEL
F/N: LLTB025L
F/N: LL01 - Clearance Safety Tag
(Affix adjacent to heater's thermostat)
Clearance to Combustibles
Clearance to Combustibles is defined as the minimum distance that must exist between the tube surface,
or reflector, and any combustible items (see Figure 1.1). It also pertains to the distance that must be
maintained from moving objects around the tube heater.
SERVICE ACCESS PANEL
F/N: LLTB024R
RE-VERBER-RAY INFRA-RED RADIANT TUBE HEATER
®
FOR INDOOR (Non-Residential) INSTALLATION ONLY.
Class IIIA Permanent Label
MODEL NO. INPUT BTU/H FOR USE WITH
DET-40-125N(-3) 125,000 / 95,000 Natural Gas
Volts AC: Manifold Pressure: Heater Type
120VAC - 60Hz 3.5 in. Inches W.C.P. C1
AMPS - Starting:
Maximum Inlet Pressure: Minimum Mounting Angle:
1.7
14 in. Inches W.C.P. 0 DEGREES
AMPS - Running:
Minimum Inlet Pressure: Maximum Mounting Angle:
1.1 5.0 in. Inches W.C.P. 45 DEGREES
Combustion Chamber:
4" Black Coated Aluminized
DESIGN COMPLIES WITH:
ANSI Z83.20b-2004-GAS FIRED LOW INTENSITY INFRA-RED HTR.
DETROIT RADIANT PRODUCTS COMPANY
Serial No.: 1208XXXXXXXXXX 0001
21400 HOOVER ROAD - WARREN, MI
(586) 756-0950 - www.drp-co.com
16" Burner
Tube
Fan
Compartment
The combustion chamber utilizes either 409
stainless, titanium alloy or aluminized steel -
depending on the model number of your heater.
WARNING
!
Placement of explosive objects, flammable objects, liquids and vapors close to
the heater may result in explosion, fire, property damage, serious injury or death.
Do not store, or use, explosive objects, liquids and vapor in the vicinity the heater.
DET-40-125N(-3)
Production Code:
Version:
Data on this label is for the model shown on this label. If your heater has been converted,
this information is not accurate. Please contact the factory for assistance.
BURNER COMPONENTS:
Gas Valve:
Circuit Board:
Wire Harness:
N.O. Switch:
N.O. VL Orifice:
N.C. Switch:
N.C. VL Orifice:
Diff Switch:
Diff VL Orifice:
Igniter:
Burner:
16" Tube:
Ind. Lights:
HEATER
For parts replacement information, contact factory at 586-756-0950 or visit www.drp-co.com/parts.
Burner Control Box Component Label
(affixed to center valve compartment lid)
MODEL NO.
DET-40-125N(-3)
Controls
Volts AC:
120V - 60Hz
Compartment
AMPS - Starting:
1.7
AMPS - Running:
1.1
Combustion Chamber:
4" Black Coated Aluminized
DESIGN COMPLIES WITH:
ANSI Z83.20b-2004-GAS FIRED LOW INTENSITY INFRA-RED HTR.
DETROIT RADIANT PRODUCTS COMPANY
21400 HOOVER ROAD - WARREN, MI
(586) 756-0950
Primary Combustion
Chamber
INSTALLER
!
AVOID EQUIPMENT FAILURE
THIS 10 FT. TUBE IS THE
COMBUSTION CHAMBER.
Rotate the tube's welded seam to bottom.
Consult the manual(s) for further details.
F/N: LLTB004
4
DET3
Serial No.: 0804XXXXXXXXXX 0001
Stock: None
DET3-125
Add-On:
7.08 N/A
(Specify TP-#'s)
36G54-224-N 840 Diag. Light: On Circuit Board
MARK10DX-117 851 Term. Block: None
3 PCS Harness 852 Transformer: 40 VA
None N/A Fan: Fasco Lg.
None Alt. Fan: 50Hz - 120V
None N/A Alt. Fan Usage: When Specified
None Relay: None
IS22010051F5166 264E Filter: None
Grey (+ / -) 24 Volt In: 3 T-plug
Norton 50 120 Volt In: 6' Blk. Cord
Mid 201B Gas In: 7/8" FC
4" Gen. 380 Extra VL Orifice: None
Yellow - 24V 828
Internal Use Only:
Orifice Type: C1 C2 C3
TYPE:
Gas:
TP-204# 19 19 19 Electric: LLWT038 Special 1:
C1
Air: Tag:
TP-44# 1 5/16" 1 7/16" 1 5/16" None Special 2:
RE-VERBER-RAY INFRA-RED RADIANT TUBE HEATER
®
FOR OUTDOOR USE AND INDOOR (Non-Residential) INSTALLATION ONLY.
Class IIIA Permanent Label
INPUT BTU/H FOR USE WITH
125,000 / 95,000 Natural Gas
Manifold Pressure: Heater Type
3.5 in. W.C.P. C1
Maximum Inlet Pressure: Minimum Mounting Angle:
14 in. W.C.P. 0 DEGREES
Minimum Inlet Pressure: Maximum Mounting Angle:
5.0 in. W.C.P. 45 DEGREES
Serial No.: 0807XXXXXXXXXX 0001
- www.drp-co.com
Secondary Combustion
Chamber (if applicable)
ALUMINIZED TUBE
(This is the Second Chamber)
This tube is constructed of aluminized coated steel and must be
placed directly after the titanium coated "Combustion Chamber"
(orange labeled tube).
150,000-200,000 Btu/h
(orange)
Series
N/A
826
55A
55B
N/A
N/A
832
333
83
17
1 7/16"
Rating
Plate
models only