Set Absolute Horizontal Print Position Esc - Epson ET-4500 Programming Manual

5.1.8 Set absolute horizontal print position ESC ( $ nL nH m1 m2 m3 m4
ESC ( $ nL nH m1 m2 m3 m4
[Name]
[Format]
[Range of Definition]
[Function]
[Initial State]
[Related Commands]
Revision: 1
Set absolute horizontal print position
1BH, 28H, 24H, nL, nH, m1, m2, m3, m4
nL=04H, nH=00H
0 <= ( m4 * 1000000H + m3 * 10000H + m2 * 100H + m1 ) * 2880 <= 209.973 mm
(absolute horizontal position setting value )
0 <= ( m4 * 1000000H + m3 * 10000H + m2 * 100H + m1 ) * 2880 <= 23808 inch
(absolute horizontal position setting value)
1) The printing position in the X direction is set to the following positive value from the origin
(left margin position) on the X axis of the position management coordinate system:
3
((m4 256 +m3 256
2)
If Left margin +(((m4 256
setting value)) is beyond the right margin position, then this command is ignored.
3) This Command is only effective in graphics mode.
-
[Setting] Commands whose settings are affected by this command.
None
[Setting] Commands that change the effects of this command.
None
[Operation] Commands whose functionality is affected by this command.
None
[Operation] Commands that change the effects of this command.
The absolute horizontal position setting units are set by the ESC (U command.
The absolute horizontal position setting units are reset to their initial state by the ESC @
and ESC (G commands.
The absolute horizontal print position is restored to its initial, default setting by the ESC @
command.
OR
2
+ m2 256 + m1) x (absolute horizontal position setting value)
3 2
+m3 256 +m2 256+m1) x (absolute horizontal position
Ver 1.00
[Operation]
2880
2016/09/02
Page: 30