Tokendisk Diskette #2 Contents; Before Installing Drivers; Installing The Client Driver For Netware - 3Com TokenLink Velocity 3C319 User Manual

Diskette #2 Contents
TokenDisk
TokenDisk diskette #2 contains the NDIS 4 miniport
driver for Windows 95 and Windows NT. This driver is
enabled for DynamicAccess Class of Service. Follow the
instructions in
Windows
for Windows
To obtain drivers for network operating systems not
included on the TokenDisk diskettes, contact the network
operating system (NOS) manufacturer or use the IBM
drivers supplied with the NOS.
For a list of supported drivers, software driver updates,
and patches for the drivers on the TokenDisk diskettes,
refer to the 3Com online delivery services listed in
Appendix

Before Installing Drivers

The 3C319 NIC must be installed in the PC, as described
in Chapter
The drivers described in this chapter are not
PnP-enabled. Before installing a driver, be sure to
disable PnP and manually configure the NIC using the
procedures described in
NIC

Installing the Client Driver for NetWare

If you did not use the AutoLink configuration utility,
follow these steps to install the DOS ODI client driver
for NetWare:
1 Make sure the 3C319 NIC is configured as described
in
2 Start the Install program on TokenDisk diskette #1.
3 From the main menu shown in
Driver Installation and Update... and press [Enter].
Chapter
95," or
NT," to install this driver.
B, "Technical
2, "Installing the 3C319
Manually."
Chapter 5, "Configuring the NIC
Before Installing Drivers
4, "Installing a Network Driver for
Chapter 6, "Installing a Network Driver
Support."
Chapter 5,
NIC."
"Configuring the
Manually."
Figure 8-1, select
8-3