3Com TokenLink Velocity 3C319 User Manual page 25

Table 2-1 Initial Settings of Configuration Options
Option
Plug and Play
Configuration Mode
I/O Base Address
Interrupt Request Level
Ring Speed
BIOS/MMIO Base Address
RAM Page Size
Shared RAM Address Range
Memory Mode
I/O Mode
IRQ Driver Type
AutoSwitch
Boot PROM
Zero Wait State
If you require other settings, you must change them
manually, as described in
NIC Manually,"
If your PnP PC does not detect and automatically
configure the 3Com NIC, do not assume the NIC is
defective. The BIOS PnP may be an early design, or
the design may be nonstandard. Use the procedures in
Chapter
and configure the NIC.
Proceed with NIC configuration and driver installation
according to the conditions described below:
Before Configuring the NIC and Installing the Driver
Default Settings in
PCs with PnP Support
Enabled
3Com
Set by PnP
Set by PnP
16 Mbps
Set by PnP
16 K
Set by PnP
16-bit
16-bit
Edge Triggered
Disabled
Disabled
Enabled
and then reboot.
5, "Configuring the NIC Manually,"
If you have a single 3C319 NIC installed and want to
load a single NetWare DOS ODI client, see
"Installing NetWare DOS Clients
Chapter 3 describes using the 3Com AutoLink utility
to configure the NIC automatically and install the
DOS 16-bit client network driver for NetWare 3.12
and 4.10 systems.
Default Settings
in PCs without
PnP Support
Enabled
3Com
A20h
2(9)
16 Mbps
CC000
16 K
D8000–DBFFF
16-bit
16-bit
Edge Triggered
Disabled
Disabled
Enabled
Chapter 5, "Configuring the
Automatically."
2-5
to disable PnP
Chapter 3,