SolarEdge SE5K Installation Manual page 30

7. Secure the Connection Unit bracket to the wall:
8. For inverters with Connection Unit - secure the Connection Unit bracket to the wall:
Mark the location of the bracket screw for the DC Safety Unit and drill the
hole.
Fasten the bracket using a standard bolt.
Verify that the bracket is firmly attached to the mounting surface.
9. Insert the two supplied screws through the outer heat sink fin on both sides of the
inverter and into the bracket (see Figure 11 ). Tighten the screws with a torque of 4.0
N*m / 2.9 lb.*ft.
Three Phase System Installation Guide MAN-01-00505-1.2
Figure 11: Hanging the inverter on the bracket
Figure 12: DC Safety Unit bracket
Chapter 3: Installing the Inverter 29