Starting A Cold Engine - Ryobi RLT254CDSO Original Instructions Manual

OPERATION

STARTING A COLD ENGINE

1. Press the primer bulb 10 times. Set the
choke lever to "Full" position.
2. Keep the throttle trigger squeezed completely
through steps 2 to 4 and pull the starter grip
until the engine attempts to start. Do not pull
the starter grip more than 4 times.
3. Set the choke lever to "half" position. Pull the
starter grip until the engine starts. Do not pull
the starter grip more than 6 times.
4. Allow the engine to run for 10 seconds. Set
the choke lever to "Run" position.
16
1
x10
1
2
1
2
3
1
2
3
4
1
2
4x
3
4 4
6x
4
6 6
2