Starting A Cold Engine - Ryobi RLT26CDSE Original Instructions Manual

OPERATION

STARTING A COLD ENGINE

1. Press the primer bulb 10 times. Set the
choke lever to "Full" position.
2. Keep the throttle trigger squeezed completely
through steps 2 to 4 and pull the starter grip
until the engine attempts to start. Do not pull
the starter grip more than 4 times. Set the
choke lever to "half" position.
3. Pull the starter grip until the engine starts. Do
not pull the starter grip more than 6 times.
Allow the engine to run for 10 seconds
4. Set the choke lever to "Run" position.
1
x10 x10
1
2
4x
3
1
2
3
6x
3
1
2
4
2
4
4 4
6 6
4
10
12