Adjustment - Kenwood NX-411 Service Manual

NX-411
Controls
Selector
Side1 key
PTT switch
Side2 key
36
TROUBLE SHOOTING
(Not used)
(Not used)
Kenwood ESN Label
NXDN ESN Label (12 digits)
MPT ESN Label (10 digits)

ADJUSTMENT

AUX(orange) key
Power switch / Volume
Universal
connector
NXDN ESN Label (12 digits)
Kenwood ESN Label
Cut-off Line
MPT ESN Label (10 digits)
Note:
A UPC code and UPC barcode is not printed on the Ken-
wood ESN Label. If necessary, cut the label at the cut-off
line and attach only the serial number.
■ Preparations for checking/tuning the transceiver
Before attempting to check/tune the transceiver, connect
the unit to a suitable power supply.
Whenever the transmitter is turned on, the unit must be
connected to a suitable dummy load (i.e. power meter).
The speaker output connector must be terminated with a
8 dummy load and connected to an AC voltmeter and an
audio distortion meter or a SINAD measurement meter at all
times during checking/tuning.
Panel Test Mode
■ Test mode operation features
This transceiver has a test mode. To enter test mode,
press and hold the [ ] key while turning the transceiver
power ON. Before the transceiver enters test mode, the
frequency version information appears on the LCD mo-
mentarily. Test mode can be inhibited by programming. To
exit test mode, turn the transceiver power OFF. The follow-
ing functions are available in test mode.