Kenwood NX-411 Service Manual page 7

4. Attach the cushion (G13-1974-04) to the VGS-1 as
shown in the fi gure.
Note:
Be sure to not cover the VGS-1 connector with the cush-
ion.
5. Insert the VGS-1 connector into the connector (CN321)
of the TX-RX PCB.
CN321
6. Insert the fl at spring (G02-1853-03) between the VGS-1
and the chassis as shown in the fi gure.
7. Attach the cushion (G13-1995-04) on the VGS-1 so that it
is attached to a part (shaded region) of the fl at spring.
INSTALLATION
VGS-1
Cushion
(G13-1974-04)
21x21x1.0mm
VGS-1
Note:
Be sure not to cover the spring part of the fl at spring with
the cushion.
Flat spring
(G02-1853-03)
Spring part
Be sure not to cover the spring part
of the flat spring with the cushion.
8. Reinstall the cover using the two screws removed in step
1.
NX-411
Cushion
(G13-1995-04)
20x30x1.0mm
VGS-1
7