Kenwood NX-411 Service Manual page 37

■ Key operation
"FNC" not appears on the sub LCD display
Key
Function
[Selector] -
Push: Test channel up
[ ] Hold: Test channel up
continuously
Push: Test channel down
[ ] Hold: Test channel down
continuously
Push: Squelch level up
[Side1]
Hold: Squelch off
[Side2] Narrow/Very narrow
[ ] Shift to panel tuning mode -
[ ] Function on
[ ] MSK 1200bps and 2400bps 2400bps:
Push: Test signaling up
[ ] Hold: Test signaling up
continuously
[AUX
-
(Orange)]
[PTT] Transmit
Use as the DTMF keypad.
[0] to [9] If a key is pressed during
and transmission, the DTMF
[#], [ ] corresponding to the key
that was presses is sent.
"FNC" appears on the sub LCD display
Key
Function
[Selector] -
[ ] Talk Around on/off
[ ] Analog/NXDN
[Side1] Function off
[Side2] LCD all lights
[ ] High power/Low power
[ ] Function off
[ ] Compander on/off
[ ] Beat shift on/off
[AUX
Function off
(Orange)]
[PTT] Transmit
[0] to [9]
and Function off
[#], [ ]
ADJUSTMENT
Display
-
Channel No.
Channel No.
Squelch level
Squelch off: icon appears
Narrow: "n"
Very narrow: "v"
"FNC" appears on the sub
LCD display
icon appears
Signaling No.
-
-
-
Display
-
On: icon appears
Analog: "A"
NXDN: "N"
-
LCD all point appears
High: "H"
Low: "L"
-
On: icon appears
On: icon appears
-
-
-
• LED indicator
Red LED Lights during transmission.
Green LED Lights when there is carrier.
• Sub LCD indicator
"FNC" Appears at function on.
• LCD display in panel test mode
(Power ON)
900MHz
Market code
(After 2sec.)
Talk Around
Temperature
Sub LCD display
An
Main LCD display
An: Analog narrow mode
Nn: NXDN narrow mode
Nv: NXDN very narrow mode Squelch level
(Analog mode only)
■ Frequency and Signaling
The transceiver has been adjusted for the frequencies
shown in the following table. When required, readjust them
following the adjustment procedure to obtain the frequencies
you want in actual operation.
• Test frequency
CH RX (MHz)
1 938.050000
2 935.050000
3 940.050000
4 938.550000
5 935.550000
6 940.450000
7~16
NX-411
Frequency range
"900MHz":
896~941MHz
Battery type detect
" L I ": Li-ion battery
" N I CD ": Ni-Cd battery
" N I MH ": Ni-MH battery
" I S ": IS Ni-MH battery
Power
Channel No. Signaling No.
TX (MHz)
899.050000
896.050000
901.950000
899.550000
896.550000
901.450000
- -
37