INDEX Adjusting the low flame Models and dimensions page page Maintenance Replacing parts Data of appliances Ignition plug Gas tap Technical data Thermocouple Electric oven resistences 60 Operating instructions Electric oven resistences 90 Construction, equipment installed and safety devices Using the appliance Cooking top (gas) Start-up Electric oven (convection-heated)
Page 3
Dimensions Fig. 1 - A ABJ00001 ABJ00002 13.5 ±1 13.5 ±1 " " 55 40 55 55 40 55 13.5 ±1 37,5 37,5 ABA20002 Burner: Off-take Gas connection B Ø 70 Data plate C Ø 90 008 - 03 - Gas cooker...
Page 4
Dimensions 55 55 13,5 1 13,5 1 27,5 27,5 52,5 1095 52,5 1095 ABA20004 1200 Gas connection Data plate 008 - 03 - Gas cooker...
2 - DATA OF APPLIANCES The instructions contained in this manual apply to our gas on the control panel. It contains all necessary reference cookers in the II2H3+ category (see table on page 6). data such as the name of the manufacturer, input pressu- The data plate is located on the front of the appliance and re, gas type setting, etc.
OPERATING INSTRUCTIONS INSTALLATION Construction, equipment installed and safety devices Assembly, installation and maintenance, i.e.: Robust steel frame, with 4 legs (adjustable in height). - assembly, connecting the gas supply, checking power 18/10 chrome-nickel steel outer panelling. rating, transforming or adapting the appliance to run on Cooking top (Gas) other types of gas, and commissioning, - connecting the appliance to the mains,...
COMMISSIONING THE APPLIANCE Before commissioning the appliance Capacity should only be measured when the appliance is at Before commissioning the appliance, remove the protective a standstill. wrapping. The heat value can be obtained from your local Gas Board. To obtain the nominal and minimum capacities in relation to Start-up the nominal pressure, consult “TECHNICAL DATA”...
control panel fixing screws. Remove the control panel, disconnect the ignition lead and REPLACING PARTS unscrew the nozzle from the nozzle holder with a spanner. Replace with a new nozzle (see “TECHNICAL DATA” table); All parts must be replaced by authorised technicians if necessary, to facilitate this operation push the air adjust- only! ment sleeve upwards loosening screw (G).
USING THE APPLIANCE Turning the electric oven on and off 90 START-UP (Fig. 6) Turning a burner on and off (cooking Select the type of heating required by turning knob 23, top) (Fig. 2) bearing in mind that the indicator light 25 stays on in all positions.
The required temperature may be chosen by turning knob THE 2002/96/EC DIRECTIVE (WEEE): 24: warning light 26 comes on and goes out when the information to users elements are switched on. To turn off the oven, turn the This informational note is meant only for owners two knobs to position ●...
Wiring diagrams ABA20004 Terminal board Switch Green indicator light Yellow indicator light Ceiling element Grill element Floor element Fan element Fan motor Thermostat. Total capacity 2,5 kW 008 - 03 - Gas cooker...
WARNING DUE TO ITS POLICY OF CONTINUAL PRODUCT IMPRO- VEMENT, THE MANUFACTURER RESERVES THE RIGHT TO MAKE ANY CHANGES DEEMED NECESSARY. THE MANUFACTURER CANNOT BE HELD RESPONSI- BLE IF THE INSTRUCTIONS CONTAINED IN THIS MA- NUAL ARE NOT OBSERVED. 008 - 03 - Gas cooker...