Related Manuals for mastro 65/40 CPE
Summary of Contents for mastro 65/40 CPE
- Page 1 Mastro mbH ¤ Hüserstraße 53 +49 (0) 23 81/ 973 71– 0 59075 Hamm / Germany +49 (0) 23 81/ 973 71– 88 w w w . m a s t r o s h o p . c o m...
- Page 2 Code 252.107.11 ELECTRIC PASTA COOKER MOD. 65/40 CPE 65/70 CPE 90/40 CPE 90/80 CPE 70/70 CPE 70/40 CPE 110/50 CPE 110/80 CPE...
-
Page 3: Table Of Contents
INDEX Paragraph Installation instructions Compliance with EEC directives Installation drawings Wiring diagrams Electrical specifications Technical data Preliminary installation instructions Regulations, technical rules and general specifications Installation 2.2.1 Electrical connection 2.2.1.1 Equipotential Water connection Paragraph User instructions Start-up Operating Instructions - Switching on and switching-off Emptying the tanks Maintenance, cleaning and care Declaration of conformity “CE”... - Page 4 INSTALLATION INSTRUCTIONS CONFORMITY WITH EEC DIRECTIVES REMARK: The electric pasta cooker are made in compliance with the basic requirements envisaged by EEC directives, in accordance with “EEC Directive 73/23 on low voltage”, “EEC Directive 89/336 on electromagnetic compatibility” and are marked “CE” according to the EEC Directive 93/68.
-
Page 5: Electrical Specifications
The data plate shows all the necessary data for the installation and can be found in the lower part on the rear of the left-hand side panel in the models 65/40 CPE and 65/70 CPE, and in the lower part in the front of the left-hand side panel in the model Mod. 70/70 CPE. -
Page 6: Preliminary Installation Instructions
PRELIMINARY INSTALLATION INSTRUCTIONS The pasta cooker must be positioned in a well-aired room, if possible under a hood to remove cooking steam thoroughly. Before starting the appliance, remove all protective film; thoroughly clean the surfaces with a soft cloth, lukewarm water and detergent, so as to remove all anti-rust products applied during the manufacturing stage, then dry with a clean cloth. -
Page 7: Electrical Connection
2.2.1 Electrical connection 1) The electric pasta cookers are designed to operate off 400 VAC+3N voltage. 2) The connection to the mains must be carried out through a suitably rated trip switch which has at least 3 mm between the contacts. Moreover, the mains voltage - when the appliance is working - must not exceed ±... -
Page 8: Water Connection
NB: The manufacturer declines all responsibility for damage resulting from non- compliance with accident prevention rules as described above. 2.2.2 WATER CONNECTION To carry out a correct installation the following must be respected: 1) The water feed pipes must be connected to the mains using cut off cocks which should always be closed when the pasta cooker is not being used or during maintenance interventions. - Page 9 USER OPERATING INSTRUCTIONS, SWITCHING ON Pasta cookers are appliances designed for cooking food and should be exclusively used by trained personnel following these operating instructions. Any other use of the appliance is to be considered improper and therefore dangerous. Before introducing food in the tank, you are advised to clean it carefully; wash with water and common detergents, then rinse well.
-
Page 10: Emptying The Tanks
EMPTYING THE TANKS Top appliances: The operator must make sure that there is a suitable container available to collect the drained off water. Insert the drainage tube with bayonet joint as shown in the drawing. To drain off the water turn the lever as shown in the drawing. Ground appliances: Connect the tank drain to the floor drain.