Using An External Power Source; Using Your Camera Abroad - Sony Cyber-shot DSC-P10 Operating Instructions Manual

Using an external power source

Jack cover
DC plug
1
, Open the jack cover and
connect the AC-LS5 AC
Adaptor (supplied) to the DC IN
jack of your camera.
Connect the plug with the v mark facing
up.
• Connect the AC Adaptor to an easily accessible
wall outlet (wall socket) close by. If any trouble
occurs while using the adaptor, immediately
shut off the power by disconnecting the plug
from the wall outlet (wall socket).
AC
Adaptor
Power cord
2
(mains lead)
, Connect the power cord (mains
lead) to the AC Adaptor and
then to a wall outlet (wall
socket).
• When you have finished using the AC Adaptor,
disconnect it from the DC IN jack of the
camera.
• The set is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket) even if the set itself has
been turned off.
Power sources
2 To wall outlet
You can use your camera in any country or
(wall socket)
area with the supplied AC Adaptor within
100 V to 240 V AC, 50/60 Hz. Use a
commercially available AC plug adaptor
[a], if necessary, depending on the design of
the wall outlet (wall socket) [b].
1
• Do not use an electronic transformer (travel
converter), as this may cause a malfunction.
Using your camera
abroad
AC-LS5
13