Using An External Power Source; Using Your Camera Abroad - Sony Cyber-Shot DSC-P9 Operating Instructions Manual

filename[D:\Documents and Settings\YAMANE\My Documents\WORKS\DSCP92\3082719111\3082719111DSCP92UC\02GB-
DSCP92UC\04BAS.FM]
01cov.book Page 15 Tuesday, February 18, 2003 3:07 PM

Using an external power source

AC Adaptor (not
supplied)
DC plug
Jack cover
1
, Open the jack cover, then
connect the AC-LS5 AC
Adaptor (not supplied) to the
DC IN jack of the camera.
Connect the plug with the v mark facing
toward the LCD screen.
• Be sure to use the AC-LS5 AC Adaptor.
Other AC adaptors cannot be used with
this camera.
• Connect the AC Adaptor to an easily accessible
wall outlet (wall socket) close by. If some
trouble occurs while using the adaptor,
immediately shut off the power by
disconnecting the plug from the wall outlet
(wall socket).
2 To a wall outlet
(wall socket)
1
Power cord
2
(mains lead)
, Connect the power cord (mains
lead) to the AC Adaptor and to
a wall outlet (wall socket).
• When you have finished using the AC Adaptor,
disconnect it from the DC IN jack of the
camera.
• The set is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket), even if the unit itself
has been turned off.
masterpage:L1-Right-01
Using your camera
abroad
Power sources
You can use your camera in any country or
area with the supplied battery charger or AC
Adaptor (not supplied) within 100 V to 240
V AC, 50/60 Hz. Use a commercially
available AC plug adaptor [a], if necessary,
depending on the design of the wall outlet
(wall socket) [b].
BC-CS2A/CS2B
• Do not use an electrical transformer (travel
converter), as this may cause a malfunction.
model name1[DSC-P92]
[3-082-719-11(1)]
15