Table of Contents
Advertisement
1
1
1
4.3.2
Stand
Refer to
Figure 4-5
for details.
1. Remove fixation screws [4] that secure the base assembly,
pull the base assembly downwards away from the catches.
Do not release the two screws in the middle of the stand.
4.3.3
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Unplug all connectors from the PSU.
2. Remove the fixation screw located right side of the mains
inlet connector.
3. Remove the other four fixation screws located at the
corners of the panel.
4. The PSU can be taken out of the set now.
4.3.4
Small Signal Board (SSB)
Refer to
Figure 4-6
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS cable connector that
connects the panel to the SSB [1].
Caution: be careful, as these are very fragile connectors!
2. Release the clamps and unplug all other connectors [2].
3. Remove all the fixation screws from the SSB [3].
4. Take out the SSB with I/O bracket.
5. The SSB can now be shifted away from side connector
cover and lifted from the set.
Refer to
Figure 4-6
4
3
1
4
Figure 4-5 Rear cover removal
for details.
Mechanical Instructions
2
4
1
4
3
3
4.3.5
Speakers
1. Gently release the tapes that holds the speaker cables.
2. Unplug the speaker connector from the SSB.
3. Take the speakers out.
When defective, replace both units.
back to
div. table
TPM9.1E LA
1
1
2
1
19230_104_120301.eps
2
Figure 4-6 SSB removal
4.
EN 13
3 × 16
1
3 × 7.5
2
M3 × 8
3
M4 × 10
4
120316
3
1
3
19230_105_120301.eps
120312
2012-Apr-27
Hide quick links:
Advertisement
Table of Contents
