Table of Contents
Advertisement
Introduction
January 2019
mounting position. Since zero trim maintains the slope of the characterization curve,
do not use it in place of a Sensor Trim over the full sensor range. For more information,
see
Reset the calibration by resetting all parameters to the factory default settings. For more
information, see
10
Perform manual zero
trim.
Resetting all parameters to factory default
settings.
•
P: measured pressure
P': modified measured value
•
CP1: calibration point 1
CP1': modified measured value for CP1
•
CP2: calibration point 2
•
1: curve of measured values at factory
setting
•
2: curve of measured values after calibration
•
P: measured pressure
P': modified measured value
•
CP1: calibration point 1
CP2: calibration point 2
CP2': modified measured value for CP2
•
1: curve of measured values at factory
setting
•
2: curve of measured values after calibration
•
P: measured pressure
P': modified measured value
•
CP1: calibration point 1
CP1': modified measured value for CP1
•
CP2: calibration point 2
CP2': modified measured value for CP2
•
1: curve of measured values at factory
setting
•
2: curve of measured values after calibration
Quick Start Guide
00825-0100-4327
Quick Start Guide
Advertisement
Table of Contents
