Routine Maintenance - MIMAKI UJF-605R II Daily Care Manual

Routine Maintenance

About use environment and care
• Use this printer in clean (less dust) environment. The use of a fan and a ventilator might
blow up dust around the printer.
• As using UV curing ink, install this printer in a well-ventilated area.
• Working environmental temperature is 15 to 30 °C (59 to 86 °F). Avoid using at lower or
higher than this.
Cautions during care
4
• Never disassemble the printer. Disassembling it causes electric shock and
failures of the printer.
• To prevent electric shock and failures to the printer, do not allow to get
inside moisture.
• Turn off power and detach power cable before doing any maintenance, or
unexpected accident may occur.
• Start maintenance after the UV lamp gets cool completely, or it may cause
burn injury.
• Benzene, thinner and chemical agents containing abrasives can deteriorate
or deform the surface of the cover.
• Do not apply lubricating oil or the like inside the printer. Such materials can
cause the printer mechanism to break down.
• UJF-605R is a printer that uses ultraviolet ray curing ink (UV ink). Make
sure to wear the supplied goggles and gloves during daily care.
• When water or alcohol are mixed into the ultraviolet ray curing ink(UV ink),
flocculation occurs. Be sure that water or alcohol do not adhere to not only
the nozzles but also near the heads, the caps, the suction nozzle and so
on.