Checking The Engine-Oil Level; Checking The Hydraulic Fluid Level - Toro TRX-16 Original Instructions Manual

DANGER
In certain conditions during fueling, static
electricity can be released causing a spark which
can ignite the gasoline vapors. A fire or explosion
from gasoline can burn you and others and can
damage property.
• Always place gasoline containers on the ground
away from your vehicle before filling.
• Do not fill gasoline containers inside a vehicle or
on a truck or trailer bed because interior carpets
or plastic truck bed liners may insulate the
container and slow the loss of any static charge.
• When practical, remove gas-powered equipment
from the truck or trailer and refuel the equipment
with its wheels on the ground.
• If this is not possible, then refuel such
equipment on a truck or trailer from a portable
container, rather than from a gasoline dispenser
nozzle.
• If a gasoline dispenser nozzle must be used,
keep the nozzle in contact with the rim of the
fuel tank or container opening at all times until
fueling is complete.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
1. Park the machine on a level surface, lower the boom,
and stop the engine.
2. Remove the key and allow the engine to cool.
3. Clean around the oil dipstick
Figure 16
1. Oil filler hole
2. Oil dipstick
4. Remove the dipstick and wipe the end clean
5. Slide the dipstick fully into the dipstick tube without
threading it into the filler neck
6. Pull the dipstick out and look at the end. The oil
should be between the Add and Full marks
(Figure 16).
3. Full mark
4. Add mark
(Figure
(Figure 16).
(Figure
7. If the oil is below the Add mark, add 10w30 engine oil
to the filler hole, checking the level frequently with the
dipstick, until the oil level reaches the Full mark.
8. Replace the dipstick.
Checking the Hydraulic Fluid
Level
Service Interval: Every 25 hours
Hydraulic Tank Capacity: 23 L (6 US gallons)
Refer to Changing the Hydraulic Fluid (page 38)
fluid specifications.
1. Park the machine on a level surface and lower the
boom.
2. Stop the engine, remove the key, and allow the engine
to cool.
3. Look into the glass bubble on the right side of the
machine. If you cannot see hydraulic fluid in the
bubble, continue this procedure to add fluid.
1. Hydraulic fluid check bubble
4. Remove the cover plate; refer to
Plate (page
5. Clean the area around the filler neck of the hydraulic
tank and remove the cap and filter from the filler neck
using a socket
16).
16).
17
1
Figure 17
Removing the Cover
23).
(Figure 18).
for hydraulic
G007808