Setup; Installing The Boom And Chain - Toro TRX-16 Original Instructions Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1

Installing the Boom and Chain

Parts needed for this procedure:
1 Boom (sold separately)
1 Chain (sold separately)
Procedure
Important: There are several boom and chain size
configurations available. Refer to you Authorized Service
Dealer to obtain the appropriate boom and chain to
meet your requirements.
1. Stop the engine and remove the key.
2. Remove the bolt, 2 saddle washers, and nut securing
the spoils auger and remove the auger
Note: Save the fasteners for future use.
Description
Boom (sold separately)
Chain (sold separately)
No parts required
No parts required
(Figure
Qty.
1
1
–
–
1. Spoils auger
2. Boom
3. Bolts
4. Double washer
5. Nuts
4).
3. Remove the 2 bolts, nuts, and double washers from the
sides of the boom
4. Loosen the adjusting bolt and jam nut
5. Slide the boom over the arm on the drive head.
6. Install the 2 bolts, nuts, and double washers removed in
step 3
them.
7. If the chain is not connected, connect the links by
pressing or hammering the clevis pin supplied with the
chain through the links.
Important: To avoid bending the chain links,
place blocks under and between the links when
hammering the clevis pin through.
8. Secure the clevis pin with the cotter pin supplied with
the chain.
12
Use
Install the boom and chain.
Check the fluid levels.
Charge the battery.
Figure 4
6. Adjusting bolt
7. Jam nut
8. Arm on the drive head
9. Drive sprocket
(Figure 4).
through the boom and arm, but do not tighten
(Figure 4).