Toro TRX-16 Original Instructions Manual page 34

3. Lift/support the side of the unit to be worked on so
that the track is 7.6 to 10 cm (3 to 4 inches) off of the
ground.
4. Back out the tensioning bolt and jam nut
5. Loosen the clamp bolts
6. Push the front road wheel rearward as far as it will go
(Figure 49).
Figure 49
7. Begin removing the track at the top of the front road
wheel, peeling it off of the wheel while rotating the
track forwards.
Note: You may need to remove the front, outside
road wheel. To remove this wheel, remove the snap
ring and cap from the center of the road wheel
50). Next remove the bolt and gasket from the center
of the wheel and pull the wheel off of the machine.
Figure 50
1. Snap ring
2. Cap
3. Bolt
8. When the track is off of the road wheel, remove it from
the machine (Figure
(Figure
(Figure 48).
4. Gasket
5. Wheel with bearings
49).
9. Beginning at the drive sprocket, coil the new track
around the sprocket, ensuring that the lugs on the track
fit between the spacers on the sprocket
10. Push the track under and between the rear and center
48).
road wheels
11. Starting at the bottom of the front road wheel, install
the track around the wheel by rotating the track
rearward while pushing the lugs into the wheel.
12. If you removed the front, outside road wheel, install
it at this time using the bolt and gasket removed
previously. Torque the bolt to 102 N-m (75 ft-lb) and
then clean, grease, and install the cap and snap ring
as instruction in the
Wheels (page 34)
13. Install the tensioning bolt and jam nut.
14. Torque the tensioning bolt to 32.5 to 40 N-m (24 to 30
ft-lb) to tighten the track.
15. Ensure that the track deflects less than 0.6 to 1 cm (1/4
to 3/8 inch) when 20.6 kg (45 lb) of force is applied to
the track span. Adjust the torque on the tensioning
bolt as needed.
16. Tighten the jam nut.
17. Tighten the clamp bolts and torque to 102 N-m (75
ft-lb).
18. Lower the machine to the ground.
19. Repeat steps
Checking and Greasing the Road
(Figure
Wheels
Service Interval: Every 250 hours
1. Remove the tracks; refer to
33).
2. Remove the snap ring and cap from a road wheel
(Figure
1. Road wheel
2. Road wheel cap
3. Check the grease under the cap and around the gasket
(Figure
of the grease, replace the gasket, and add new grease.
34
(Figure 49).
Checking and Greasing the Road
section.
3 through 18 to replace the other track.
Replacing the Tracks (page
51).
Figure 51
3. Snap ring
51). If it is dirty, gritty, or depleted, clean out all
(Figure 49).