Troubleshooting - PDC spas Luxury Series Owner's Manual

Opera ng System,
Se ng filter cycle
Se ng filter or
dura on
purge cycle start
me
(not available on purge
systems)
The display will show
FSxx, "xx" represen ng The display will show
the star ng hour of the
Fdxx, "xx" represen ng
cycle. Use the Up or the dura on in hours of
Down key to adjust the
the filter cycle. Use the
hours. Use the Light Up or Down key to
key to jump to the next
adjust the dura on. Use
parameter, filter the Light key to jump to
dura on (Fd). the next parameter,
filter or purge frequency
(FF)
0=no filtra on
24=con nuous filtra on
(0 not recommended)
Se ng filter or
purge cycle start
me
The display will show
FSxx, "xx" represen ng
the star ng hour of the
cycle. Use the Up or
Down key to adjust the
hours. Use the Light
key to jump to the next
parameter, filter
dura on (Fd).
Troubleshoo ng Reference
Hr
An internal hardware error has been detected.
Contact dealer or service provider.
HL
The system has shut down the heater because the
temperature at the heater has reached 119°F (48°C). Do
not enter the weater! Remove the spa cover and allow
the water to cool down, then shut power off and power
your spa up again to reset the system.
AOH
Temperature inside the spa cabinet is too high, causing the
internal temperature in the power unit to increase above
normal limits. Open cabinet sidewall and wait un l error
clears.
LifeStyle Series
—in.k300 Series Control
Se ng filter or
purge cycle
frequency
The display will show
FSxx, "xx" represen ng
the number of cycles
per day. Use the Up or
Down key to adjust the
frequency. Use the
Light key to jump to
the next parameter,
economy mode (EP)
The "Filter Cycle"
indicator lights when
filter is on and flashes
when suspended.
Se ng filter or
purge cycle start
me
The display will show
FSxx, "xx" represen ng
the star ng hour of the
cycle. Use the Up or
Down key to adjust the
hours. Use the Light
key to jump to the next
parameter, filter
dura on (Fd).
Se ng economy Se ng economy
mode start me
The mode allows you The display will show
to lower the tempera‐ ESxx, "xx" represen ng
ture set point of the the hour at which the
spa by 20°F (11°C) economy mode be‐
during a certain period comes ac ve. Use the
of the day. Up or Down key to
adjust the hour. Use
The display will show
the Light key to jump
EPx, the "x"
to the next parameter,
represen ng the state
economy dura on (Ed).
of the progranned
economy (0=disabled, When the Economy
1=enabled). Use the mode is ON, the display
arrow keys to enable will toggle between the
or disable economy "Eco" message, the
mode. Use the Light me, and the water
key to jump to the next temperature.
parameter, economy
start me (ES).
Cooldown Water Temperature
Regula on
The display will show
The display will show
FSxx, "xx" represen ng
the star ng hour of the FSxx, "xx" represen ng
cycle. Use the Up or the star ng hour of the
Down key to adjust the cycle. Use the Up or
hours. Use the Light Down key to adjust the
key to jump to the next hours. Use the Light
parameter, filter key to jump to the next
parameter, filter
dura on (Fd).
dura on (Fd).
FLO
The system does not detect any water flow while
the primary pump is opera ng. Check and open
water valves. Check for water level. Clean filter.
If the problem persists, call your service supplier.
Prr
A problem is detected with the temperature probe.
Call your service supplier.
OH
The water temperature in the spa has reached 108°
F (42°C). Do not enter the water! Remove the spa
cover and allow the water to cool down to a lower
temperature. Call your service supplier.
42
Se ng economy
dura on
The display will show
ESxx, "xx" represen ng
the dura on in hour of
the economy mode. Use
the Up or Down key to
adjust the hour. Use the
Light key to jump to the
next parameter,
temperature unit.
24=con nuous economy