Fully Recessed Installation - PDC spas Luxury Series Owner's Manual

Installa on Guidelines and Site Prepara on
Outdoor Installa on Considera ons (cont'd):
6. Locate the hot tub with an awareness to sunlight exposure, views, access, property lines, ligh ng, wind direc on,
shielding, sep c tanks, plants, trees. (Chemicals in the water splashed from your hot tub may damage nearby plant life.)
7. Consider the loca on of the nearest bathroom or dressing room.
8. If your hot tub is to be located on a second story, be posi ve support is adequate. Call your builder and a structural
engineer.
9. Posi oning with adequate space for access to components for maintenance and general servicing. It is suggested 3 .
on all cabinet sides.
10. Be sure to note any other considera ons, such as aesthe cs or privacy concerns, that may affect the safety or
enjoyment of using the hot tub.
11. Provide adequate drainage away from the equipment and adequate eleva on to allow draining by siphon, should
it be required.
12. Loca on of electrical supply. 120/240 volt systems require hard wire installed from the electrical source to the
spa support pack terminal. ALL EQUIPMENT MUST BE GROUND FAULT CIRCUIT PROTECTED (NOT SUPPLIED) AT THE
POWER SOURCE. ALL ELECTRICAL WIRING OF THE SPA SUPPORT EQUIPMENT MUST COMPLY WITH THE NATIONAL
ELECTRIC CODE.
13. Loca ons at least 5 (1.52 m) from all metal surfaces. (A spa may be installed within 5 feet of metals surfaces
providing each metal surface is permanently connected by a No. 6AWG (8.4 mm2) copper conductor a ached to the
wire connector on the terminal box provided for this purpose.) ALL INSTALLATIONS MUST COMPLY WITH ARTICLE 680
OF THE U.S. NATIONAL ELECTRIC CODE AND ANSI/NFPA 70‐1984.
Par ally or Fully Recessed Installa ons:
PDC Spas does not recommend this type of installa on, although if this is what you have chosen for your new hot tub,
please review the following considera ons.
1. A system for preven ng collec on and pooling of water must be designed in accordance to local authori es.
2. If installed in designated floodways, addi onal a en on to maximum water load entering that floodway must be
addressed to prevent water from accumula ng below grade. The hot tub is not designed to be submerged in water and
will void all warran es.
3. Unit must be level and self‐suppor ng and NEVER backfilled with sand, gravel or dirt. This will void all warran es.
4. Plan for complete drainage.
5. Must have proper ven la on so equipment does not overheat.
6. Must provide at least 3 feet of access around all sides of the hot tub. Warranty does not cover costs associated
with gaining access for service and maintenance.
7. Below grade drainage needs to be evaluated based upon specific region rainfalls. This analysis must be done by a
qualified local engineer to ensure proper drainage.
27