EDAN M3A User Manual page 83

M3A Vital Signs Monitor User Manual
5 Holding the thermometer too long may cause a higher ambient temperature reading
of the probe, which could make the body temperature measurements lower than
usual.
6 Check whether the thermometer is damaged once it drops. If you cannot make sure
of it, send the complete device to your local dealer for recalibration.
7 Keep the unit dry and away from any liquids and direct sunlight.
8 The probe should not be submerged into liquids.
9 For more details about using the infrared ear thermometer, refer to the
accompanying operating instructions of the thermometer.
10 The monitor outfitted with the TH module must not be used together with other
electrosurgery equipment, for example, ESU.
11.2.2 Measuring Procedure
1. Align the center of the probe to the center of the probe cover. Make sure to place the
adhensive side of probe cover upward.
2. Insert the probe into the probe cover on the probe cover loader until the probe cover clicks in
place.
NOTE:
If the probe cover did not install well, the icon
thermometer, and you cannot take the ear temperature (with four beep sounds heard and
without reading on the LCD when measuring).
3. Press ON/MEM button of the thermometer. The icon
thermometer and you will hear two beep sounds.
4. Gently pull the ear back to straighten the ear cannal and snugly fit the probe into the ear
canal, aiming towards the membrane of the eardrum to obtain an accurate reading.
CAUTION
- 76 -
TEMP Monitoring (Optional)
will flash on the LCD of the
will display on the LCD of the