Camera Reset - Bosch FLEXIDOME IP starlight 8000i Series Installation Manual

38 en | Maintenance
Clear bubbles offer maximum sensitivity by allowing as much light through as possible. Tinted
bubbles offer covertness by making it difficult to see from the outside the direction the
camera is facing.
For instructions on how to replace the bubble, refer to the respective Quick Installation Guide.
9.4

Camera reset

To reset the camera to factory settings:
1.
2.
3.
4.
5.
6.
2019.07 | 02 |
Remove the camera module from the camera base.
Unscrew and remove the connection PCB from the camera base.
Attach the connection PCB to the camera module.
Connect a network cable with PoE or a 24V AC / 12-26V DC cable to power the camera
module.
Press tightly and hold the reset button on top of the SD card slot for 15 seconds. The
LED light by the reset button flashes in red.
Release the reset button.
Installation manual
FLEXIDOME IP starlight 8000i
Bosch Security Systems B.V.