Bosch FLEXIDOME IP starlight 8000i Series Installation Manual page 35

FLEXIDOME IP starlight 8000i
Moisture/condensation
inside the bubble,
camera leaking.
No audio transmission to
remote station.
The unit does not report
an alarm.
Bosch Security Systems B.V.
The maximum number of
connections has been reached.
Housing is not closed properly.
Closing seals are damaged.
Rubber grommet not placed
correctly.
Cable diameter or shape is not
as specified.
Air vents are blocked due to
dirt/water.
Air vents are damaged or loose.
Camera has been off for an
extensive period of time.
Hardware fault.
Faulty cable connections.
Incorrect configuration.
The audio voice connection is
already in use by another
receiver.
Alarm source is not selected.
No alarm response specified.
Installation manual
Troubleshooting | en
Wait until there is a free
connection and call the
transmitter again.
Re-install camera and check for
proper closure.
Please contact your supplier or
system integrator, or go directly
to Bosch Security Systems
customer service.
Re-install rubber grommet.
Re-install camera with proper
cabling.
Gently clean air vents.
Please contact your supplier or
system integrator, or go directly
to Bosch Security Systems
customer service.
Turn camera on and leave it on
until condensation clears.
Check that all connected audio
units are operating correctly.
Check all cables, plugs,
contacts and connections.
Check audio parameters on the
Audio configuration and LIVE
page functions pages.
Wait until the connection is free
and then call the sender again.
Select possible alarm sources
on the Alarm sources
configuration page.
Specify the desired alarm
response on the Alarm
connections configuration page;
if necessary change the IP
address.
2019.07 | 02 |
35