Mechanical Installation; Before You Start - SEW-Eurodrive DR2..71/BE Series Operating Instructions Manual

4

Mechanical installation

4.1

Before you start

INFORMATION
Observe the safety notes in chapter 2 of this documentation for the mechanical in-
stallation.
INFORMATION
The mounting position for installation must correspond with the specifications on the
nameplate.
Only install the drive if the following conditions are met:
•
•
•
•
The above mentioned information refers to standard orders. The conditions might be
different when you order drives other than the standard. Observe any differing condi-
tions in the order confirmation.
Functional safety If the drive has the FS logo on the nameplate, observe the information on mechanical
installation in the corresponding addendum to the operating instructions.
The specifications on the nameplate of the drive correspond to the supply system
or the output voltage of the frequency inverter
The drive is undamaged (no damage caused by transport or storage)
All transport protection has been removed
You are certain that the following requirements have been met:
– Ambient temperature according to the nameplate.
Note that you can also limit the temperature range of the gear unit (see gear
unit operating instructions).
Any differing specifications on the nameplate must be observed.
– No oils, acids, gases, vapors, dusts, radiations, etc.
– Installation altitude max. 1000 m above sea level
Observe the chapter "Designated use" (→ 2 10) in chapter 2.
– Note the restrictions for encoders
– Special Design: Drive configured in accordance with ambient conditions.
Mechanical installation
Before you start
Operating Instructions – AC Motors
4
31