Table of Contents
Advertisement
Before starting a new experimental session, we suggest checking the
memory which may contain some data of the previous trial.
If it is the case, enter the proper software level and
paragraph 7.1
7.1
Memory Reset
From the Memory menu, the F3 key (RES) enables the operator to reset the data stored
in the memory.
This command can be useful, for instance, before starting a new experimental session, if
the operators prefers to cancel the data saved from previous experiments.
Answer (YES) (F3 key) or (NO) (F4 key) to
"ARE YOU
the question:
The Memory menu automatically appears
also when the memory is
means it has reached its maximum capabil-
ity of about 300 measures.
7.1.1
"Memory Full" Message
FULL" message appears during acquisition, the operator has three op-
If the
"MEMORY
tions:
if not interested in the data saved in the memory, the researcher may simply
depress the F4 (ESC) key, followed by the F3 (RES) and confirm the reset by
answering F3 (YES) to the question
7.1.When the data previously saved in the memory are to not to be can-
celled, the researcher may print and/or send them to the memory key or PC
as previously explained (see paragraph 7-MEMORY MANAGEMENT).
There is also the possibility to ignore the indication of
go on with the experiment. The data acquired onwards will not be saved.
Consider that, in this case, the memory remains fully loaded and the display
reminds it by showing the message
SURE?".
fully
loaded, which
37370 Instruction Manual (Rev. 0)
To interrupt the print-out response of the
stored data, depress the F4 (ESC) key for
one second at least.
"ARE YOU
FULL" at each measure.
"MEMORY
Page 20
RESET
the memory, see
SURE?", see paragraph
"MEMORY
FULL" and
Advertisement
Table of Contents
