AccuTemp EVOLUTION Series Installation & Operator's Manual page 9

Installation Manual I Installation
3.5.2 Double Stand Installation Instructions
The AccuTemp double stand can be equipped with adjustable
height feet or can be equipped with non-adjustable casters and
accommodates (2) E6 model Evolutions (FIGURE 4).
1. Before mounting a steamer on a stand with casters engage
the brakes on the two front locking casters, pressing on the
"ON" handle of the brake mechanism.
2. Always mount the first EVOLUTION on the bottom of the
stand. To mount the bottom steamer, carefully lift and place
it on the horizontal mounting brackets, ensuring that the (4)
mounting holes on the underside of the Evolution are lined
up with the mounting holes on the brackets.
3. Then, using a 7/16" wrench, fasten one pair of the 1/4"-20
hex bolts and 1/4" split lock washers through the underside
of each stand bracket mounting hole into the Evolution and
tighten securely.
4. Once the bottom steamer has been installed, carefully
lift and place the top Evolution steamer on the horizontal
mounting brackets, ensuring that the (4) mounting holes
on the underside of the Evolution are lined up with the
mounting holes on the brackets.
5. Then, using a 7/16" wrench, fasten one pair of the 1/4"-20
hex bolts and 1/4" split lock washers through the underside
of each stand bracket mounting hole and tighten securely.
6. With the SNH-20 stand, level the appliances by adjusting the
feet found at the ends of each stand leg, either up or down
as needed.
3.5.3 Flush Mount Installation
To Flush mount the appliance to a counter, follow these steps:
1. Drill 4 holes as seen in FIGURE 2.
2. Attach the appliance to counter top with (4) 1/4-20 x 3/4"
hex head bolts and 1/4-20 split lock washers.
3. Apply a bead of high temp food grade silicone caulking
around the perimeter and smooth out.
FIGURE 2
MP4010-1903
FIGURE 3: MANUAL FILL UNIT ON SINGLE STAND
FIGURE 4: MANUAL UNITS ON A DOUBLE STAND
8