AccuTemp EVOLUTION Series Installation & Operator's Manual page 10

Installation Manual I Installation
3.6 Steamer Connections
The Evolution Electric Steamer is available in a connected and
connection-less models.
Both the connection-less and connected model will require a
an electrical connection.
CONNECTED UNITS:
The connected model in addition to the electrical connection
will require a water connection and access to a floor drain or
sink to route a drain hose (not supplied) to allow condensate to
be removed and to drain the steamer when required.
See FIGURE 5 for identifications of the required steamer
connections.
CONNECTIONLESS UNITS:
This model must be manually filled with tap water and must be
filled throughout the cooking process to assure consistent cook
times.
Do not use the "Low Water Indicator" as your indication
that this steamer requires water as this actually turns off the
heat to the product thus stopping the cooking process.
A full size steam table pan or a 1/1 gastronome pan must
installed in rails under the steamer any time the steamer is
operating and anytime that the steamer is being cleaned or
drained of the water in the cooking chamber. Failure to follow
this directions will cause a the steamer to fail which is not
covered under the limited warranty (FIGURE 6).
FIGURE 5 - TEXT ENCIRCLED BOLD ARE SHARED
CONNECTIONS BETWEEN BOTH MANUAL AND AUTO-FILL
UNITS
3/4" Cooking Chamber Exhaust Vent
Power Plug
MP4010-1903
FIGURE 6: MANUAL FILL UNIT ON SINGLE STAND
DRAIN PAN
3/4" GHT Potable Water
Connection
Only)
(Connected Models
9